How to Remove & Replace Old Caulk

by Matt Mihalcin 11/22/2020

Image by bidvine from Pixabay

If you have a bath or shower that required caulking, chances are that caulk has seen better days. It's soft, so abrasive cleaners wear away at it. This may cause gaps or ragged holes that trap residue. And even if it's all in one piece, mildew and grime will likely stain it over time. 

But beyond the cosmetics, if your caulk is old and porous, it could be letting water behind the tub or shower. This leads to warping of the outer liner and even severe water damage that could go unnoticed for years. The wall or floor could be rotting beneath the surface as we speak.

So if your caulk doesn't look its best, or it's been five or more years since you replaced it, the time is now to remove that old caulk and lay down new.

What you'll need

For this project, you need:

  • Plastic or latex gloves because you'll be working with harsh chemicals
  • Caulk gun
  • Caulk
  • Caulk softener solution
  • A utility knife with a new blade or a caulk-removing tool (both work well)
  • Putty knife
  • Ammonia-free tub cleaning solution
  • 1/3-cup bleach
  • Paintbrush
  • Rag
  • Step one: soften the caulk

    If you try to remove caulk without softening it first, it will not come off cleanly. You'll end up doing a lot of extra work. So before you begin, open a window or make sure the room is well-ventilated. Put on your gloves. And then follow the product's instructions for application. It will vary.

    Step two: slice the caulk & remove

    Carefully use your utility knife to cut the caulk. On a good day, the caulk will come off clean at this point. But even with caulk softener, you may have places where it does not. This is especially true if someone tried to re-caulk in the past without completely removing the old stuff.

    If this happens, you'll need some needle nose pliers and a little patience to pull off the stubborn pieces. Now, rake the remained caulk away with a putty knife.

    Step three: clean the surface & prepare it

    Clean the edges, removing any mildew or scum with your ammonia-free tub cleaning solution. Then go over the area with a 1/3-cup to one-gallon bleach solution. Use a paintbrush to work the solution into the crevices. Rinse and then dry the surface thoroughly with your rag.

    And, in case you're wondering, ammonia and chlorine don't mix and could be deadly. So please check those labels. 

    Step four: apply the caulk & let it dry

    Here's the easy part. Use the caulk gun to create an even stream of caulk where you removed the old caulk. Wait at least 24 hours before running water into the tub or shower.

    And that's it. Doesn't your shower look great? For more quick projects you can do yourself to spruce up your home, follow our blog.

    About the Author
    Author

    Matt Mihalcin

    Matt has been in Real Estate since 2006 in the Denver area. He is a 3rd generation Colorado native of 30+ years who currently lives in Broomfield. He leverages his experience and network to save clients time and money for easy and low stress transactions. He enjoys mountain biking, skiing and hiking in his free time.